China Sealed Extended Base Stainless Steel Pulping Vessel Manufacturers Factory Suppliers

The Stainless Steel Bottom Entry Beating Tank is used for mixing and beating solid pigments in pigment and chemical plants. Its multi-stage agitation system combines straight rod, frame, and...

The Stainless Steel Foot Operated Bag Filter uses a corrosion-resistant stainless steel body and a foot-operated cover-opening mechanism. It removes suspended impurities through physical screening...

A Stainless Steel Buffer Tank helps reduce pressure fluctuations caused by pump start-up and shutdown or sudden valve closure. Depending on its design, it may use a compressed-air chamber, an...

The Stainless Steel Activated Carbon Adsorber uses activated carbon to remove pollutants from exhaust gases or water. In gas-phase applications, a fan moves exhaust through the adsorber, where...

The Stainless Steel Falling Film Evaporator feeds liquid into the upper tube box of the heating chamber. A distribution device spreads the liquid evenly across the heat exchange tubes, where it...

A Stainless Steel Shell and Tube Heat Exchanger transfers heat between hot and cold fluids without allowing them to mix. The fluids flow on opposite sides of the tube walls, with countercurrent...

Also known as a spiral stainless steel duct, the Stainless Steel Spiral Wound Duct is a circular ventilation duct made by spiral rolling and pressing the lock seams along a continuous forming...

The Stainless Steel Cooler with Cover transfers heat from a hot fluid to a cold fluid without phase change. It is mainly used for cooling in chemical plants, power generation, and other industrial...

A Stainless Steel Receiving Tank is selected according to the installation space, stored medium, hygiene requirements, and operating pressure. Vertical models occupy less floor space and can...

The Stainless Steel Demister is a gas-liquid separation device designed for high-temperature and corrosive environments. It is mainly used in wet flue gas desulfurization and other industrial...

The Wound PPH Vacuum Metering Tank is made from PPH raw material using German spiral winding technology. Unlike tanks assembled by manually butt-welding plastic plates, its one-piece winding...

Unlike packed absorption towers, the absorption process takes place inside graphite tubes. Raw gas enters from the top, while water or another suitable absorbent is distributed along the inner...